How to replace the BMW ECU easily and safely by CG FC200?
There are three methods to operate in the different situations.
The important thing to replace the BMW ECU is to read the original ISN and write it into the replacement ECU.
Here take BMW CAS3 ECU as an example.
Method 1:
If the original BMW ECU can communicate normally, we can use the ECU Programmer to read the original data and write into the new replacement ECU. It's the simplest and fastest way to operate. No need to reprogram.
Method 2:
Case: The original ECU failed to communicate and read data, but the original Anti-theft system and key are normal.
Solution: Use CGDI Prog BMW Key Programmer or other programmers to read the IMMO data and original ISN by the original key, then use CG FC200 ECU Programmer to write the ISN into the replacement ECU
For example, the original BMW MEV17.2.1 N46 ECU is damaged and cannot read/write data. If we use the first method, the problem cannot be solved, so we need to use the following method.
1.Check if the original Anti-theft system and key are normal.
2.If both are OK, use programmer to read CAS data. It requires you to weld the CAS and programmer expertly.
3.Run CGDI BMW software and select “CAS3 Key Match”, load the CAS3 data just read, and put the original key into the coil of CGDI BMW, then the ISN data will be identified.
4.Write the ISN data into the replacement BMW ECU by CG FC200.
5.Finally, install the ECU back to the BMW car.
Method 3:
When we do not know the original ECU ISN, and the module data of the original car cannot be read and written, the anti-theft of the original car is not normal or the key cannot be used normally. We need to use FC200 to read the ISN inside the replaced engine ECU, write this ISN into the anti-theft with CGDI, and then use this ISN to add a new key.
إرسال تعليق